Install in one click

Flash AirRadar to your Waveshare ESP32-S3-Touch-LCD-7 directly from this page — no IDE, no drivers to fight.

Requires desktop Chrome or Edge. Connect the board by USB-C first.

v7.2.6

A 12/24-hour clock toggle, and two touch fixes. The range stepper's left arrow stepped the wrong way — both chevrons went up, so the only way to a shorter range was all the way round. And the ? now sits properly beside the cog instead of stranded away from it, with the two touch zones no longer overlapping each other or the card below. Carries every earlier v7.2 fix.

Your browser can't flash over USB — use desktop Chrome or Edge. Serial access was blocked — allow it and retry.
  1. Plug the board into your computer with a USB-C data cable.
  2. Flip the onboard UART switch to the flashing position if upload fails.
  3. Click Connect & Install and pick the USB JTAG/serial or wchusbserial port.
  4. Wait for the flash to finish — the radar boots straight into first-run setup.
v7.2.6 · github.com/MrRonco/AirRadar · by Franco Raso